Fun facts about gray iron castings


Release date:

2021-02-24

What exactly is a gray iron casting? Today, the editor will give you a brief introduction. Gray iron castings are characterized by their high clay content, low moisture level, and relatively low addition of coal powder. When preparing the molding sand for high-density gray iron castings, keep the following points in mind:

What exactly is a gray iron casting? Today, the editor will give you a brief introduction. Gray iron castings are basically characterized by high clay content, low moisture, and a relatively low addition of coal powder. When preparing the molding sand for high-density gray iron castings, keep the following points in mind:

 Gray iron casting

① The clay content and silt content—sand with higher clay content exhibits increased strength as compaction pressure rises. In sand molds, the sum of effective clay and dead clay is equivalent to the silt content. However, both excessively high or low silt content can negatively impact the various performance characteristics of the mold sand.

② Moisture: In the manufacturing of gray iron castings, moisture is the primary factor determining the clay content and viscosity of the molding sand. Neither too much nor too little moisture is acceptable—excessive moisture can lead to a deterioration in the clay's binding strength and reduce the flowability of the sand, resulting in uneven mold density. Conversely, insufficient moisture makes it difficult to thoroughly mix the sand, leading to low sand strength, increased brittleness, poor mold-release properties, and ultimately causing sand adhesion defects in the casting.

③ The original sand granularity should not be overly concentrated. The sand particles should ideally be round or polygonal in shape. Typically, either three-sieve sand or four-sieve sand is chosen. Note that when using high-density molding, the sand mold tends to have higher density, leading to greater expansion during pouring.

The reasons for brittle fracture cracks in gray iron castings: When the stress generated in the material of a gray iron casting under external force exceeds its inherent fracture strength, cracking occurs—this is one of the critical factors leading to mechanical component failure. The fracture process in gray iron castings is quite complex, typically involving three stages: initiation of internal cracks, crack propagation, and finally, fracture. Fractures that do not exhibit significant plastic deformation are classified as brittle fractures. Under normal tensile stress, brittle fracture occurs when the material separates along the weakest crystallographic planes—those with the least resistance between atoms. In gray iron castings, brittle fracture cracks arise because, after the material is subjected to stress, moving dislocations encounter barriers at grain boundaries and impurity phases, leading to dislocation pile-ups. When the stress concentration created by these pile-ups surpasses the material's strength, initial cracks begin to form. Once initiated, these brittle fracture cracks propagate at an extremely rapid rate. Notably, if the material's yield stress simultaneously exceeds both the crack-nucleation stress and the fracture stress, any crack that does emerge will lead to immediate fracture without prior plastic deformation.

 

Copyright © 2025 TONGREN IND.AND TRADING CO., LIMITED.

Business license